Download Print this page

Cisco ONS 15454 Troubleshooting Manual page 24

Hide thumbs Also See for ONS 15454:

Advertisement

Table 4-1
Error Messages (continued)
Error/Warning
ID
Error/Warning Message
EID-3177
The node name cannot be empty.
EID-3178
The node name ''{0}'' cannot exceed {1} characters.
EID-3179
The protect card is in use.
EID-3180
The 1+1 protection group does not exist.
EID-3181
The Y-cable protection group does not exist.
EID-3182
The topology element is in use and cannot be deleted as
requested.
EID-3183
An error occurred while deleting the protection group.
EID-3184
No {0} was selected.
EID-3185
This ring has an active protection switch operation and cannot
be deleted at this time.
EID-3186
The node is busy: {0} is {1} and cannot be deleted as requested. The request cannot be completed.
EID-3187
An error occurred while deleting the trap destination.
EID-3188
An error occurred during authentication. The password entered
is invalid.
EID-3189
The sum of the {0} must be between {1} and {2}.
EID-3214
The number of high order circuits for the line could not be
retrieved.
EID-3215
An error occurred while refreshing.
EID-3216
The proxy port is invalid.
EID-3217
The statistics could not be refreshed.
EID-3218
The automatic node setup could not be launched.
EID-3219
The automatic node setup information could not be refreshed.
EID-3220
An error occurred while refreshing row {0}.
EID-3222
The statistics could not be cleared.
EID-3225
An error occurred while refreshing the pane.
EID-3226
The {0} termination(s) could not be deleted.
{1}
EID-3227
A baseline could not be recorded. Performance metrics will
remain unchanged.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-24
Chapter 4
Description
The specified name is empty.
The specified name exceeds the specified
character limit.
Refer to the error message text.
Create a 1+1/LMSP protection group.
Refer to the error message text.
You cannot delete the topology element
which is in use.
CTC encountered an error while deleting
the protection group.
You must select an item before completing
this task.
Refer to the error message text.
CTC encountered an error deleting the trap
destination.
The password you entered is invalid. Enter
the password again.
Refer to the error message text.
The number of High Orders (STS/VC4) for
the line is not available.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC could not refresh statistics values.
Refer to the error message text.
Failure trying to retrieve automatic node
setup information.
Error refreshing the specified row.
Refer to the error message text.
Used frequently in pane classes to indicate
a general error condition when trying to
refresh from the model.
Refer to the error message text.
CTC failed to set the baseline values while
provisioning NE. Previous values remain
unchanged.
Error Messages
78-19418-01

Advertisement

loading