Cisco ONS 15454 Troubleshooting Manual page 28

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
WID-3283 Before activating a new version, ensure that you have a
database backup from the current version.
WID-3284 Reverting to an older version.
WID-3285 Applying FORCE or LOCKOUT operations might result in
traffic loss.
WID-3286 The ring status is INCOMPLETE. CTC cannot determine if
there are existing protection operations or switches in other
parts of the ring. Applying a protection operation at this time
could cause a traffic outage. Please confirm that no other
protection operations or switches exist before continuing.
WID-3287 There is a protection operation or protection switch present on
the ring. Applying this protection operation now will probably
cause a traffic outage.
WID-3288 The status of this ring is INCOMPLETE. CTC will not be able
to apply this change to all of the nodes in the {0}.
EID-3290 The specified provisionable patchcord(s) could not be deleted. Refer to the error message text.
EID-3291 The revertive behavior cannot be changed because a protection
switch is active.
EID-3292 An error occurred while resetting the shelf.
EID-3293 No such provisionable patchcords exists.
EID-3294 No RMON thresholds are available for the selected port.
EID-3295 This card does not support RMON thresholds.
EID-3296 Buffer-to-buffer credit is only supported for Fibre Channel (FC)
and FICON.
EID-3298 This interfaces does not support ALS auto restart.
EID-3300 Duplicate OSPF area IDs are not permitted.
EID-3301 The LAN metric cannot be zero.
EID-3302 The standby {0} is not ready.
EID-3303 The DCC area ID and {0} conflict.
{1}
EID-3304 The DCC number is out of range.
EID-3305 OSPF cannot be active on the LAN interface when the
backbone area is set on a DCC interface.
EID-3306 Ethernet circuits must be bidirectional.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-28
Chapter 4
Description
Refer to the warning message text.
CTC is being reverted to an older version of
application.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Change the ring status to apply the change
to all nodes in the ring type.
Protection switch should not be active to
change the revertive behaviour.
CTC encountered an error while resetting
the node.
You are attempting to delete a provisionable
patchcord that does not exist. This happens
when multiple instances of CTC are
running and attempting to delete the same
provisionable patchcord concurrently.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
OSPF area IDs should be unique.
Refer to the error message text.
Standby controller card is not ready.
DCC Area ID and ring type, specified by
{0}, conflict each other due to the details
specified by {1}.
Enter a DCC number that is within the range
You cannot have the default OSPF area on a
DCC while OSPF is enabled on the LAN.
Refer to the error message text.
Error Messages
78-19418-01