Cisco ONS 15454 Troubleshooting Manual page 11

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-2143 No online help version was selected.
The online help book cannot be deleted.
EID-2144 An error occurred while deleting the online help book(s).
{0}
EID-2145 No nodes appear to have a Cisco IOS card.
EID-2146 This is a security violation.
You may only logout of your own account.
EID-2147 This is a security violation.
You may only change your own account.
EID-2148 This is a security violation.
You cannot delete the account under which you are currently
logged in.
WID-2149 There is no exportable content in this view.
WID-2150 The node {0} is not initialized.
Please wait and try again.
WID-2152 Spanning tree protection is being disabled for this circuit.
WID-2153 Adding this drop will make the circuit a PCA circuit.
WID-2154 Monitor circuits cannot be created on a port grouping circuit.
WID-2155 Switch counts might not be fully supported on some nodes.
{0}
WID-2156 The manual roll mode is recommended for dual rolls.
For auto dual rolls, please verify that roll to facilities are in
service and error-free.
WID-2157 The roll(s) cannot be completed.
{0}
EID-2158 The roll mode is invalid.
{0}
EID-2159 The roll is not ready for completion.
{0}
EID-2160 The roll is not connected.
{0}
78-19418-01
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
Description
Select the version of online help, and
proceed.
You cannot delete the specified online help.
Refer to error message.
You cannot logout of an account other than
your own.
You cannot change an account other than
your own.
You cannot delete the account you are
currently logged in.
Refer to the error message text.
Wait till the specified node is initialized and
try again.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
The specified nodes do not support switch
counts completely.
Refer to the warning message text.
CTC could not complete the roll because
the roll is destroyed, in an incomplete state,
in a TL1_roll state, is cancelled, or is not
ready to complete.
There are two roll modes: auto and manual.
For a one-way circuit source roll, the roll
mode must be auto and for a one- way
circuit destination roll, the roll mode must
be manual.
The roll is not ready for completion.
Refer to error message text.
4-11