Cisco ONS 15454 Troubleshooting Manual page 58

Table 4-1 Error Messages (continued)
Error/Warning
ID Error/Warning Message
EID-6313 The multicast IP address count must be in range [1-256]
EID-6314 Could not retrieve TTY session for the chosen CRS.
EID-6315 CRS provisioning failed.
{0}
EID-6316 The chosen node is not a CRS-1.
EID-6317 The value specified for IPv6 Address or IPv6 Default Router is
invalid.
EID-6318 The value specified for Prefix Length is invalid. Valid range of
values is 0 to 128.
EID-6319 IPv6 mode can be enabled only if SOCKS and firewall are
enabled on the node.
EID-6320 IPv6 mode cannot be enabled on a node if RIP is enabled.
EID-6321 IPv6 mode cannot be enabled on a node if 'OSPF on LAN' is
enabled.
EID-6322 IPv6 Address cannot be specified for {0} when IPv6 mode is
not enabled on the node.
EID-6323 CTC was unable to delete SnmpV3 Target.
EID-6324 The card mode is invalid in this configuration.
EID-6325 SW version mismatch on node {0}: found {1}, expected {2}.
EID-6326 The CRS node {0} version[{1}] is greater than the supported
version[{2}]. The creation of ochtrail circuits between CRS
nodes will not be disabled, but there could be unexpected
behaviors.
EID-6327 The end point of patchcord have an incompatible wavelength.
EID-6329 Protection/AIS action cannot be both set to squelch.
EID-6330 The node failed to restart the Pseudo IOS CLI service on the
selected port. Try using another unreserved port that is not
being used within the 1024 - 65535 range.
EID-6331 That port is already in use.
Also note that the Pseudo IOS port may not be changed if any
Pseudo IOS connections are currently open.
WID-6332 All previously configured IPv6 destinations will become
unreachable if IPv6 mode is disabled. It is recommended that
you remove all IPv6 related provisioning before disabling IPv6
mode.
Do you want to continue?
WID-6333 The NE default {0} not available in the selected NE Defaults
Tree.
WID-6334 Could not find the NE default {0}.
WID-6335 CTC was unable to create a new Target account.
Cisco ONS 15310-MA SDH Troubleshooting Guide, Release 9.1 and Release 9.2
4-58
Chapter 4
Description
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Refer to the warning message text.
Error Messages
78-19418-01