Cycles For Milling Pockets, Studs And Slots - HEIDENHAIN TNC 370 User Manual

8
Cycles
8.3 Cycles for Milling Pockets, Studs and Slots
Die TNC offers 9 cycles for milling pockets, studs and slots:
4 POCKET MILLING (rectangular)
Roughing cycle, without automatic pre-positioning
212 POCKET FINISHING (rectangular)
Finishing cycle, with automatic pre-positioning and
2nd setup clearance
213 STUD FINISHING (rectangular)
Finishing cycle, with automatic pre-positioning and
2nd setup clearance
5 CIRCULAR POCKET
Roughing cycle, without automatic pre-positioning
214 CIRCULAR POCKET FINISHING
cle, with automatic pre-positioning and
215 CIRCULAR STUD FINISHING
Finishing cycle, with automatic pre-positioning and
2nd setup clearance
3 SLOT MILLING
Roughing/Finishing cycle, without automatic
pre-positioning, vertical downfeed
210 SLOT WITH RECIPROCATING PLUNGE-CUT
Roughing/Finishing cycle, with automatic
pre-positioning and reciprocating plunge-cut
211 CIRCULAR SLOT
Roughing/Finishing cycle, with automatic
pre-positioning and reciprocating plunge-cut
-
8-16
TNC 370 -