HEIDENHAIN TNC 370 User Manual page 324

12 Tables, Overviews and Dialogs
12.5 TNC Error Messages
TNC error messages during test run and program run
l
Define the arc and its end points unambiguously.
l
If you enter polar coordinates, define the polar coordinate angle
correctly.
You have attempted to calculate with illegal values
l
Define values within the range limits.
l
Choose probe positions for the 3D touch probe that are farther
separated.
l
Calculations must be mathematically possible.
Each axis can only have one value for position coordinates.
l
Program the MIN and MAX points according to the instructions.
l
Choose a ratio of sides less than 84:l.
l
When programming with PGM CALL, copy the BLK FORM into the
main program.
l
A chamfer block must be inserted between two straight line blocks.
l
A running program cannot be changed.
l
Do not edit a program while it is being transferred or executed.
l
Enter complete information for tangential arcs
l
Enter end points that lie on the circular path.
l
Define the cycle with all data in the proper sequence.
l
Do not call coordinate transformation cycles.
l
Define a cycle before calling it.
l
Enter a pecking depth other than 0.
l
Conclude subprograms with LBLO.
l
Program CALL LBL for subprograms without REP.
l
Program CALL LBL for program section repeats to include the
repetitions (REP).
l
Subprograms cannot call themselves.
l
Subprograms cannot be nested in more than 8 levels.
l
Main programs cannot be nested as subprograms in more than 4
levels.
12-l 8
TNC 370