HEIDENHAIN TNC 370 User Manual page 127

5 Programming Tool Movements
4
5.5 Path Contours - Polar Coordinates
Select polar coordinates.
Enter the radius from the pole to the straight line end point, for
example PR = 5 mm.
POLdR C#RDINA% ANILE PA ?
--
L
,
Enter the angle from the reference axis to PR, for example PA = 30".
If necessary, enter also:
Radius compensation
Feed rate
Miscellaneous function
Resulting NC block: LP PR+5 PA+30
5-28
TNC 370