HEIDENHAIN TNC 370 User Manual page 296

IO
External Data Transfer
e
The TNC features an W-232-C data interface for
transferring data to and from other devices. It can
be used in the PROGRAMMING AND EDITING
operating mode and in a program run mode.
Possible applications:
l
Blockwise transfer (DNC mode)
l
Loading program files into the TNC
l
Transferring program files from the TNC to
external storage devices
l
Printing files
RLBERT .H 162
CYCLS .H 1304
135K2 .I 2::
108
TOOL .T 8224 M
TOOLP .TCH 36 M
xx. x
-25,500 T
+21.325
q B
+150.000
MS/g
C +90,000
Fig. 10.1:
Screen layout
for
external
data transfer
10.1
Functions for External Data Transfer
IIB
Select file management.
Select functions for external data transfer.
Transfer all programs from the storage medium
into the TNC
Display programs for transfer into the TNC
Transfer selected program into the TNC
TRRNSFER
Transfer selected program to an external device
Transfer all programs which are in the memory of
the TNC to an external device
Display a program directory of the files stored in the
external device
SHOW EXT 1,
i
DIRECTORY
:)
j'
Aborting data transfer
To abort a data transfer process, press DEL.
Jf you are transferring data between two TNC controls, the receiving control must be started first. To load programs
in HEIDENHAIN dialog format, the program input setting under MOD must be on HEIDENHAIN (see page 1 I-3).
Blockwise transfer
In the operating modes PROGRAM RUN/FULL SEQUENCE and SINGLE
BLOCK, it is possible to transfer programs which exceed the memory
capacity of the TNC by means of blockwise transfer with simultaneous
execution (see page 3-6).