HEIDENHAIN TNC 370 User Manual page 314

12 Tables, Overviews and Dialogs
12.1 General User Parameters
Madrining and program run
Position display in the tool axis
J
MP 7285 Display referenced to tool datum: 0
Display referenced to tool face: 7
4
Effect of cycle 11 SCALING
MP74 70
SCALING effective in 3 axes: 0
SCALING effective in the working plane only: 7
Tool compensation data in probe cycle TOUCH PROBE 0
MP7477 Overwrite current tool data with the calibrated data of the 3D touch probe: 0
Retain current tool data: 7
Behavior of cycle 6 ROUGH-OUT
MP7420 Mill channel around contour in clockwise direction for islands and counterclockwise direction for
pockets: +O
Mill channel around contour in clockwise direction for pockets and counterclockwise direction for
islands: +7
-
First mill the channel, then rough-out: +O
First rough-out, then mill the channel: +2
Merge compensated contours: +O
Merge uncompensated contours: +4
Complete one process for all infeeds before switching to the other process: +O
Mill channel and rough-out for each infeed depth before continuing to the next depth: +8
Overlap factor for cycle 4 POCKET MILLING and cycle 5 CIRCULAR POCKET
d
MP7430 0.1 to 7.474
Effect of M functions
MP7440 Program stop with M06: +O
No program stop with M06: +7
No cycle call with M89: +O
Modal cycle call with M89: +2
Program stop with M functions: +O
No program stop with M functions: +4
Angle of change in direction still traversed at constant contouring speed (corner with RO, inside corner also
radius-compensated)
Applicable for operation with servo lag and feed precontrol.
MP7460
0.0000 to
779.9999
["I
Coordinate display for rotary axis
d
MP7470 Angle display up to f 359.999": 0
Angle display up to f 30 000": 7
--
12-8
TNC 370