HEIDENHAIN TNC 370 User Manual page 283

9
3D Touch Probes
L
9.4 Digitizing with a Triggering 3D Touch Probe (Optional)
L
L
L
To program TCH PROBE 6.0:
1 m---Ey
Select the probing functions.
Select the MEANDER digitizing cycle.
LIm DlRECTIQM 2
c
J
Enter the line direction, for example X.
Enter the distance of travel by which the probe lifts off the surface
during scanning, for example 0.5 mm.
I
Enter the maximum probe point interval, for example 0.8 mm.
Resulting NC blocks:
TCH PROBE 6.0 MEANDER
TCH PROBE 6.1 DIRECTN: X
TCH PROBE 6.2 TRAVEL:
0.5 L.SPAC: 0.2
PP.INT: 0.8
t!!i
Before you enter Cycle 6: MEANDER, the program must have a range defined in digitizing Cycle 5: RANGE.
TNC 370
9-25