Installation In A Rack; Standalone - Teldat M1 Installation Manual

3 Components and Power Supply
Inserting the expansion card
Fig. 9:
(7) Screw the tray to the device. See
Screw the tray to the front panel
Fig. 10:
(8) Connect a terminal to the console and check that the device detects the expansion card.

3.3 Installation in a rack

The Teldat M1 device family can be installed in a 19" rack. The strips and screws needed are not provided by default
and need to be acquired separately.
Both strips are attached to the device by means of 4 screws, two on each side, as shown in Figure 11.
Anchor bolts for a rack
Fig. 11:

3.3.1 Standalone

The Teldat M1 routers can be placed as a standalones on a flat, stable surface. The adhesive rubber feet must be
stuck to the underside panel to prevent the device from sliding.
10
Fig. 10 on page 10.
Teldat S.A.
Teldat Router M1/M1L