Network [N] Ieee8021X Eap Md5; Network [N] Ieee8021X Eap Peap; Network [N] Ieee8021X Eap Tls; Network [N] Ieee8021X Eap Ttls - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Network [n] IEEE8021X Eap Md5

n: 1..1
Define the Md5 (Message-Digest Algorithm 5) mode. This is a Challenge Handshake
Authentication Protocol that relies on a shared secret. Md5 is a Weak security.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-MD5 protocol is disabled.
On: The EAP-MD5 protocol is enabled.

Network [n] IEEE8021X Eap Ttls

n: 1..1
Define the TTLS (Tunneled Transport Layer Security) mode. Authenticates LAN clients
without the need for client certificates. Developed by Funk Software and Certicom. Usually
supported by Agere Systems, Proxim and Avaya.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-TTLS protocol is disabled.
On: The EAP-TTLS protocol is enabled.

Network [n] IEEE8021X Eap Tls

n: 1..1
Enable or disable the use of EAP-TLS (Transport Layer Security) for IEEE802.1x
connections. The EAP-TLS protocol, defined in RFC 5216, is considered one of the most
secure EAP standards. LAN clients are authenticated using client certificates.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-TLS protocol is disabled.
On: The EAP-TLS protocol is enabled.
D15362.17 DX70 and DX80 Administrator Guide CE9.14, OCTOBER 2020.
Configuration Peripherals Maintenance

Network [n] IEEE8021X Eap Peap

n: 1..1
Define the Peap (Protected Extensible Authentication Protocol) mode. Authenticates LAN
clients without the need for client certificates. Developed by Microsoft, Cisco and RSA
Security.
Requires user role: ADMIN, USER
Default value: On
Value space: Off/On
Off: The EAP-PEAP protocol is disabled.
On: The EAP-PEAP protocol is enabled.

Network [n] IPStack

n: 1..1
Select if the device should use IPv4, IPv6, or dual IP stack, on the network interface. NOTE:
After changing this setting you may have to wait up to 30 seconds before it takes effect.
Requires user role: ADMIN, USER
Default value: Dual
Value space: Dual/IPv4/IPv6
Dual: When set to Dual, the network interface can operate on both IP versions at the
same time, and can have both an IPv4 and an IPv6 address at the same time.
IPv4: When set to IPv4, the device will use IPv4 on the network interface.
IPv6: When set to IPv6, the device will use IPv6 on the network interface.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
105
Administrator Guide
Device settings Device settings Appendices