Removal of Condenser Fan Blade
Remove the nut holding the condenser fan blade onto the
fan motor shaft. Then slide the fan blade off the shaft.
Removal of Condenser Fan Motor
Remove the four nuts & washers located on each corner of
the fan motor. Then slide the fan motor off the four
supporting bolts.
Note: To completely remove the fan motor away from the
unit, you will also need to unclip the connecting harness
attached to the outdoor PCB.
Remove Outdoor Electric Box Assembly
To remove the top PCB cover, unscrew the left & right side
screws. Then lift off.
Disconnect all relevant wiring.
Remove the two screws that anchor the electronic box
assembly to the supporting frame.
Then lift out.
Condenser
Fan Blade
Nut
Motor
Motor Support
Electric Box Assy
Nut
Screw
Page 126 KSSSI116