Control Of Up & Down Swing; (Ion Filter) Cold Plasma Function - Electrolux KSV26HRC Service Manual

Control of Up & Down Swing:
Small Horizontal Louver
After powering up the unit, the swing motor controlling the small horizontal louver will rotate anticlockwise to position 0.
If the swing function has not been activated, the horizontal louver will turn clockwise to position D1 in HEAT mode.
If the swing function has been activated, the horizontal louver will swing between 0 and D1.
There are 7 swing settings for this horizontal louver, positions O, A1, B1, C1 & D1.
When activated, the swing function will operate between O & D1, and can be stopped at any position in between by the
use of the remote control.
When the unit is turned off, the horizontal louver will close at position 0.
Note: The Swing function can only be turned on & off via the (Swing-V) button on the remote control.
Note: The small louver will only activate in Heating mode, not in Cooling mode.
Large Horizontal Louver
After powering up the unit, the swing motor controlling the large horizontal louver will rotate anticlockwise to position 0.
If the swing function has not been activated, the horizontal louver will turn clockwise to position D in HEAT mode, or
turn clockwise to level position L in other modes.
If the swing function has been activated, the horizontal louver will swing between L and D.
There are 7 swing positions for the large horizontal louver, positions L, A, B, C & D.
When activated, the swing function will operate between L & D, and can be stopped at any
position in between by the use of the remote control.
When the unit is turned off, the horizontal louver will close at position 0.

(ION Filter) Cold Plasma Function:

To activate the ION Filter, press the ION Filter button
The ION Filter generator releases plasma (both positive and negative) from the air outlet into the serviced area.
To deactivate the ION Filter, repress the ION Filter button located on the remote control.
Page 53 KSSSI116
located on the remote control.