Turbo Button; X-Fan Button - Electrolux KSV26HRC Service Manual

Sleep Mode 3
In this mode the sleep temperature curve is manually set (DIY).
(1) After selecting Sleep mode 3, press and hold the Turbo button until the remote control enters into user defined
sleep setting status, the remote control will display "1 hour", temperature display will show the corresponding
temperature of last setting sleep curve and blink (The first use will display the original factory setting).
(2) Adjust " " and " " buttons will change the setting temperature for the first hour of sleep, after setting the
temperature, press the Turbo button for confirmation.
(3) The hour of sleep mode will be automatically increased on the remote control, to the 2nd, 3rd hour of sleep
mode and so on with each press of the Turbo button.
(4) Repeat the above step (2 ) ~ (3) operation, until 8 hours of sleep temperature setting is finished.
The sleep curve program is finished The remote control will resume the original timer display. The
temperature display will return to the original setting.
The sleep program can be checked by selecting sleep mode 3, pressing and holding the Turbo button and then repeat
pressing the turbo button to review the sleep program temperatures without pressing the " " or " " buttons. In this mode, if
the no button were to be pressed for 10 seconds, the display will revert to normal operation.

TURBO Button:

Pressing this button while the air conditioner is operating will put the fan into the high speed turbo mode. The indicator on
the remote control will show. Turbo mode will be cancelled if the mode or fan speed is changed.

X-FAN Button:

Pressing X -FAN button in COOL or DRY mode, the icon is displayed and the indoor fan will continue operation for 10
minutes in order to dry the indoor unit even though you have turned off the unit.
Page 50 KSSSI116