Electrolux KSV26HRC Service Manual page 123

Remove Evaporator & Indoor Fan Motor
Remove the screw supporting the connection pipe clamp.
Then remove the clamp.
Remove the two screws supporting the evaporator side
cover.
Remove the single screw supporting the evaporator to the
chassis.
Carefully dislodge each side of the evaporator from the
chassis & the supporting clamp. Then remove the
evaporator.
Remove the four screws supporting the fan motor cover
into position. Then remove the cover.
Loosen off the locking screw located on the fan blade
spindle.
Carefully slide out the fan motor shaft away from the fan
blade.
Page 123 KSSSI116
KSV26 & 35CRC/HRC models only
Screw
Clamp, Pipe
Connection
Evaporator
assembly
Screw
Side Cover
Clamp
Chassis
Screw
Motor clamp
Locking Screw
Motor
Fan Blade