Electrolux KSV26HRC Service Manual page 131

Remove Fan Motor
Remove the four nuts & washers located on each corner of
the fan motor. Then slide the fan motor off the four
supporting bolts.
Note: To completely remove the fan motor away from the
unit, you will also need to unclip the connecting harness
attached to the outdoor PCB.
Remove Outdoor PCB Assembly
Remove the single screw holding the outdoor PCB cover
into position.
Then lift off.
Remove all plug & wiring connections from the outdoor
PCB to the various components.
Remove the four screws located in each top corner of the
PCB.
Press the heat sink upwards while unclipping the plastic
surround that supports the PCB in place.
Then lift out.
Remove 4-Way Valve
Remove the single screw that attaches the electronic coil to
the four-way valve. Then slide off the coil.
Note: Before removing the four-way valve, ensure the
replacement four-way valve assembly (including connecting
piping) is on hand.
Page 131 KSSSI116
Motor
Motor Support
Electric Box
Screws
4-Way
Valve Assy
Nut
Electric Box Cover