Notes On The Use Of The Communication Port - Xerox Document FaxCentre 165c Service Manual

LinkFax icons for reception, plus an Internet
LinkFax icon for transmission, which appears fur-
ther up the screen.
In addition, from this point on, whenever the sys-
tem is restarted, the following picture will appear
on the display for a few seconds:
WARNING
If no E-mail application has been installed, the
Internet LinkFax icon will not appear at the
bottom of the screen and the icon that ap-
pears on the screen will not be active. Fur-
thermore, each time the system is restarted,
the following message will appear:
... to remind you that you do not have access
to any E-mail applications.
The two Internet LinkFax icons are auto-
matically reset following installation of an E-
mail application.
NOTES ON THE USE OF THE
COMMUNICATION PORT
Having installed the LinkFax 8 module, the PC port
to which the facsimile machine is connected will
be exclusively dedicated to the management
of bubble ink jet facsimile machines (Fax Port)
XEROX DFC165 & DWC165c Service Manual
supported by the module.
Should you need to use this port for devices other
than facsimile machines, you can temporarily
deselect the port and then reselect it:
• Double click on the Fax Manager icon:
• Select the fax port (LPT1 in the example):
• Confirm the Deselect port button to enable
the port for standard operation (Printer
Port):
• To reselect the Fax Port, you will have to con-
firm the Select Port button.
If you are using an application that can only con-
trol the facsimile machine via a serial port, you
can temporarily redirect the serial port to
the parallel port. In this way, the application
will "think" that it is using a serial port, while in
reality the facsimile machine is controlled via the
parallel port.
• Double click on the Fax Manager icon and se-
lect the relevant serial port (COM1 in the
example):
9-7