7.2.9 Removing the Scanner Unit
1) Remove the casing (see section 7.2.2)
2) Remove the power supply unit (see section 7.2.3)
3) Remove the console (see section 7.2.6)
4) Unplug the scanner motor cable and the CCD flat cable from the motherboard
(see fig. 7-30)
scanner motor cable
5) Lift the scanner unit and pull it forwards so that you can unplug the ground wire
on the left and unscrew the right ground wire (see fig. 7-31).
ground
wire
6) After replacing the Scanner Unit, perform the ADF TEST (par. 6.1.6) and
SCANNER SHADING (par. 6.1.8).
7-20
CCD flat cable
Fig. 7-30
Fig. 7-31
XEROX DFC165 & DWC165c Service Manual
ground
wire