Xerox Document FaxCentre 165c Service Manual page 48

In addition to these indispensable parameters, the following parameters may also be
set:
- enabling of extension telephone for activating the facsimile machine ( REMOTE
START), by means of a one-digit code (0-9)
- number of rings after which the facsimile machine prepares for automatic
reception (RING COUNT: 01 / 02 / 04 / 08)
- time (in seconds) after which the facsimile machine with the fax/phone feature
enabled switches to fax mode (FAX/TEL TIMER: 15 / 20 / 30 / 40)
- time (in seconds) after which the facsimile machine connected to an external
telephone answering machine switches to fax mode, when there is no incoming
message (SILENCE LAPSE: 3 / 4 / 6 / 8 / 10 / NO).
a) The facsimile machine is in stand-by mode
b) Access the main menu and select the TEL.LINE SETUP
submenu of the INSTALLATION menu.
c) Press START
d) Set the parameters to the desired values, following the
explanatory flow chart shown below:
RING COUNT: 01
FAX/TEL/FAX: 15
SILENCE LAPSE: 4
E LAPSE: 3
3-18
Setting
TEL.LINE SET UP
PRIV. LINE (PBX)
PBX DIAL:PULSE
EXT.LINE:PREFIX EXT.LINE EARTH
TYPE PREFIX
PSTN DIAL:PULSE
REMOTE START:ON REMOTE START:OFF
TYPE CODE
RING COUNT 02
FAX/TEL TIMER: 20
SILENCE LAPSE: 6
PUBL. LINE (PSTN)
PBX DIAL:TONE
EXT.LINE: FLASH
PSTN DIAL:TONE
RING COUNTY:04 RING COUNT:08
FAX/TEL TIMER: 30 FAX/TEL TIMER: 40
SILENCE LAPSE 8 SILENCE LAPSE: 10
XEROX DFC165 & DWC165c Service Manual
Display
AUTOMATIC RX
09-05-95 14:58
TEL.LINE SETUP
FUNC/START/STOP
PUBL.LINE (PSTN)
START/STOP/← /→
SILENCE LAP