Link-Aggregation Irf-Enhanced; Link-Aggregation Mode - HP 12500 Series Command Reference Manual

Examples
# Configure the destination MAC address as the global link-aggregation load sharing criterion.
<Sysname> system-view
[Sysname] link-aggregation global load-sharing mode destination-mac

link-aggregation irf-enhanced

Use link-aggregation irf-enhanced to enhance the Selected port capacity for link aggregation in
IRF mode.
Use undo link-aggregation irf-enhanced to restore the default.
Syntax
link-aggregation irf-enhanced
undo link-aggregation irf-enhanced
Default
The Selected port capacity is not enhanced in IRF mode.
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
This command can be configured only on devices in IRF mode.
If one end is configured with this command, make sure the other end is also configured with this
command. Otherwise, link aggregation might not work.
On a device with the command configured, do not set the maximum number of Selected ports
allowed in the aggregation group to 1.
When this command is configured, the Selected port capacity (the maximum number of Selected
ports allowed in an aggregation group) of the IRF fabric is the sum of the IRF members' Selected
port capacities. The final Selected port capacity is the smaller one of the two ends.
After you remove the configuration of this command, the Selected port capacity of the IRF fabric
becomes that of an IRF member device.
Examples
# Enhance the Selected port capacity for link aggregation in IRF mode.
<Sysname> system-view
[Sysname] link-aggregation irf-enhanced

link-aggregation mode

Use link-aggregation mode dynamic to configure an aggregation group to operate in dynamic
aggregation mode and enable LACP.
Use undo link-aggregation mode to restore the default setting.
30