Port-Isolate Enable; Port-Isolate Group - HP 12500 Series Command Reference Manual

Related commands

port-isolate enable

port-isolate enable
Use port-isolate enable to assign a port to an isolation group.
Use undo port-isolate enable to remove a port from an isolation group.
Syntax
port-isolate enable group group-number
undo port-isolate enable
Default
No ports are assigned to an isolation group.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Parameters
group group-number: Specifies an isolation group number in the range of 1 to 16.
Usage guidelines
The configuration in Layer 2 Ethernet interface view applies only to the interface.
The configuration in Layer 2 aggregate interface view applies to the Layer 2 aggregate interface
and its aggregation member ports. If the device fails to apply the configuration to the aggregate
interface, it does not assign any aggregation member port to the isolation group. If the failure
occurs on an aggregation member port, the device skips the port and continues to assign other
aggregation member ports to the isolation group.
Before you assign ports to an isolation group, make sure the isolation group already exists.
Examples
# Assign ports GigabitEthernet 3/0/1 and GigabitEthernet 3/0/2 to isolation group 2.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] port-isolate enable group 2
[Sysname-GigabitEthernet3/0/1] quit
[Sysname] interface GigabitEthernet 3/0/2
[Sysname-GigabitEthernet3/0/2] port-isolate enable group 2
Related commands
display port-isolate group

port-isolate group

Use port-isolate group to create an isolation group.
39