Lldp Compliance Cdp - HP 12500 Series Command Reference Manual

Parameters
disable: Specifies the disable mode, where CDP-compatible LLDP cannot receive or transmit CDP
packets.
txrx: Specifies the TxRx mode, where CDP-compatible LLDP can send and receive CDP packets.
Usage guidelines
For your device to work with Cisco IP phones, you must enable CDP-compatible LLDP globally and
then configure CDP-compatible LLDP to operate in TxRx mode on the specified ports.
Examples
# Enable CDP-compatible LLDP globally and configure CDP-compatible LLDP to operate in TxRx
mode on GigabitEthernet 3/0/1.
<Sysname> system-view
[Sysname] lldp compliance cdp
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] lldp compliance admin-status cdp txrx
Related commands

lldp compliance cdp

lldp compliance cdp
Use lldp compliance cdp to enable CDP compatibility globally.
Use undo lldp compliance cdp to restore the default.
Syntax
lldp compliance cdp
undo lldp compliance cdp
Default
CDP compatibility is globally disabled.
Views
System view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
Because the maximum TTL allowed by CDP is 255 seconds, the TTL configuration must be no more
than 255 seconds for CDP-compatible LLDP to operate with Cisco IP phones. The TTL configuration
is the product of the TTL multiplier and the LLDPDU transmit interval, which should be configured
to be no more than 1/3 of the TTL value.
Examples
# Enable LLDP to be compatible with CDP globally.
<Sysname> system-view
[Sysname] lldp compliance cdp
137