HP 12500 Series Command Reference Manual page 152

vlan-name [ vlan-id ]: Advertises VLAN name TLVs. The vlan-id argument specifies a VLAN ID in the
TLVs to be advertised, is in the range of 1 to 4094, and defaults to the lowest VLAN ID on the port.
dot3-tlv: Advertises IEEE 802.3 organizationally specific LLDP TLVs.
link-aggregation: Advertises link aggregation TLVs.
mac-physic: Advertises MAC/PHY configuration/status TLVs. The switch cannot send this type of
TLVs but can receive them.
max-frame-size: Advertises maximum frame size TLVs.
power: Advertises power in MDI TLVs and power stateful control TLVs.
med-tlv: Advertises LLDP-MED TLVs.
capability: Advertises LLDP-MED capabilities TLVs.
inventory: Advertises the following TLVs: hardware revision, firmware revision, software revision,
serial number, manufacturer name, model name, and asset ID.
location-id: Advertises location identification TLVs.
civic-address: Inserts the normal address information about the network device in location
identification TLVs .
device-type: Sets a device type value in the range of 0 to 2. Value 0 specifies a DHCP server. Value 1
specifies a switch. Value 2 specifies an LLDP-MED endpoint.
country-code: Sets a country code, corresponding to ISO 3166.
{ ca-type ca-value }&<1-10>: Configures address information, where ca-type represents the address
information type in the range of 0 to 255, ca-value represents address information, a string of 1 to
250 characters, and &<1-10> indicates that you can specify up to 10 ca-type ca-value pairs.
elin-address: Inserts telephone numbers for emergencies in location identification TLVs.
tel-number: Sets the telephone number for emergencies, a string of 10 to 25 characters.
network-policy: Advertises network policy TLVs.
power-over-ethernet: Advertises extended power-via-MDI TLVs.
Usage guidelines
You can enable the device to advertise multiple types of TLVs by using this command without the
all keyword specified.
If the MAC/PHY configuration/status TLV is not advertisable, none of the LLDP-MED TLVs will be
advertised regardless of whether they are advertisable. If the LLDP-MED capabilities TLV is not
advertisable, the other LLDP-MED TLVs will not be advertised regardless of whether they are
advertisable.
Examples
# Enable the device to advertise link aggregation TLVs of the IEEE 802.3 organizationally specific
TLVs on GigabitEthernet 3/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] lldp tlv-enable dot3-tlv link-aggregation
147