HP 12500 Series Command Reference Manual page 103

Table 22 Command output
Field
Vlan-interface2 current state
Line protocol current state
Description
The Maximum Transmit Unit
Internet protocol processing : disabled
Internet Address is 192.168.1.54/24
Primary
P Packet Frame Type
Hardware Address
IPv6 Packet Frame Type
Last clearing of counters
The brief information of interface(s)
under route mode
Link: ADM - administratively down;
Stby – standby
Protocol: (s) - spoofing
Interface
Description
Physical state of a VLAN interface:
•
DOWN ( Administratively )—The administrative state of the
VLAN interface is down, because it has been shut down with
the shutdown command.
• DOWN—The administrative state of the VLAN interface is
up, but its physical state is down. The VLAN that corresponds
to this interface does not contain any physical port in the UP
state (possibly because the ports are not well connected or
the lines have failed).
•
UP—Both the administrative state and the physical state of
the VLAN interface are up.
Link layer protocol state of a VLAN interface:
•
DOWN—The protocol state of the VLAN interface is down.
•
UP—The protocol state of the VLAN interface is up.
Description string of a VLAN interface.
MTU of a VLAN interface.
The interface is not capable of processing IP packets. This
information is displayed when the interface is not configured
with an IP address.
The primary IP address of the interface is 192.168.1.54/24. This
information is displayed only if the primary IP address is
configured for the interface.
IPv4 outgoing frame format.
MAC address that corresponds to a VLAN interface.
IPv6 outgoing frame format.
Time when the reset counters interface vlan-interface
command was last used to clear the interface statistics.
Never indicates the reset counters interface command has
never been used on the interface since the device's startup.
Brief information about Layer 3 interfaces.
Link layer state of the interface:
•
ADM—The interface has been administratively shut down. To
recover its physical state, run the undo shutdown command.
•
Stby—The interface is operating as a standby interface.
If the network layer protocol state of an interface is shown as UP,
but its link is an on-demand link or not present at all, its
protocol attribute includes the spoofing flag (which is a letter s
in parentheses).
Abbreviated interface name.
98