Stp Enable - HP 12500 Series Command Reference Manual

When the setting is configured in Layer 2 Ethernet interface view, it takes effect on only that
interface.
When the setting is configured in Layer 2 aggregate interface view, it takes effect on only the
aggregate interface.
When the setting is configured on a member port in an aggregation group, it takes effect only after
the port leaves the aggregation group.
Examples
# Configure GigabitEthernet 3/0/1 as an edge port.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] stp edged-port
Related commands
stp bpdu-protection
•
stp loop-protection
•
stp root-protection
•

stp enable

Use stp enable to enable the spanning tree feature.
Use undo stp enable to disable the spanning tree feature.
Syntax
stp enable
undo stp enable
Default
The spanning tree feature is enabled on all ports.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
Predefined user roles
network-admin
mdc-admin
Usage guidelines
When you enable the spanning tree feature, the device operates in STP, RSTP, or MSTP mode,
depending on the spanning tree mode setting.
When you enable the spanning tree feature, the device dynamically maintains the spanning tree
status of VLANs, based on received configuration BPDUs.
When you disable the spanning tree feature, the device stops maintaining the spanning tree status.
When the setting is configured in Layer 2 Ethernet interface view, it takes effect on only that
interface.
When the setting is configured in Layer 2 aggregate interface view, it takes effect on only the
aggregate interface.
66