Lldp Fast-Count; Lldp Global Enable - HP 12500 Series Command Reference Manual
Routing, layer 2 - lan switching
Hide thumbs
Also See for 12500 Series:
- Configuration manual (402 pages) ,
- Network management and monitoring command reference (320 pages) ,
- Command reference manual (157 pages)
Table of Contents
Advertisement
Predefined user roles
network-admin
mdc-admin
Usage guidelines
LLDP-CDP packets use only SNAP encapsulation.
Examples
# Configure the encapsulation format for LLDPDUs as SNAP on GigabitEthernet 3/0/1.
<Sysname> system-view
[Sysname] interface GigabitEthernet 3/0/1
[Sysname-GigabitEthernet3/0/1] lldp encapsulation snap
lldp fast-count
Use lldp fast-count to set the number of LLDPDUs sent each time fast LLDPDU transmission is
triggered.
Use undo lldp fast-count to restore the default.
Syntax
lldp fast-count count
undo lldp fast-count
Default
The number is 3.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
count: Sets the number of LLDPDUs sent each time fast LLDPDU transmission is triggered. The value
range is 1 to 10.
Usage guidelines
When fast LLDPDU transmission is enabled, the device shortens the LLDPDU transmit interval to 1
second and restores it to the normal value after sending a certain number of LLDPDUs in
succession. That number can be changed by using this command.
Examples
# Configure the device to send four LLDPDUs each time fast LLDPDU transmission is triggered.
<Sysname> system-view
[Sysname] lldp fast-count 4
lldp global enable
Use lldp global enable to enable LLDP globally.
139
Advertisement
Table of Contents
