Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 340

Error Error name
code
3652H Axis 2 error stop
(deceleration
stop)
3653H Axis 3 error stop
(deceleration
stop)
3654H Axis 4 error stop
(deceleration
stop)
3655H Axis 5 error stop
(deceleration
stop)
APPENDIX
338
Appendix 3 Error Code
Error details and cause
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUNPAUSE/RUNSTOP operation
was executed.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUNPAUSE/RUNSTOP operation
was executed.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUNPAUSE/RUNSTOP operation
was executed.
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUNPAUSE/RUNSTOP operation
was executed.
Action
• Eliminate the error that has caused the stop
and restart the positioning.
• Eliminate the error that has caused the stop
and restart the positioning.
• Eliminate the error that has caused the stop
and restart the positioning.
• Eliminate the error that has caused the stop
and restart the positioning.
Detailed Diagnostic
information timing
Error location
At END
information instruction
and system execution, at
configuration instruction
information execution
Error location At END
information instruction
and system execution, at
configuration instruction
information execution
Error location At END
information instruction
and system execution, at
configuration instruction
information execution
Error location At END
information instruction
and system execution, at
configuration instruction
information execution