Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 339

Error Error name Error details and cause
code
3643H Axis 3 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3644H Axis 4 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3645H Axis 5 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3646H Axis 6 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3647H Axis 7 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3648H Axis 8 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
3649H Axis 9 command • The 32-bit range was exceeded when
speed error the unit of the command speed was
converted.
• When the positioning was started, the
command speed was set to 0.
364AH Axis 10 • The 32-bit range was exceeded when
command speed the unit of the command speed was
error converted.
• When the positioning was started, the
command speed was set to 0.
364BH Axis 11 • The 32-bit range was exceeded when
command speed the unit of the command speed was
error converted.
• When the positioning was started, the
command speed was set to 0.
364CH Axis 12 • The 32-bit range was exceeded when
command speed the unit of the command speed was
error converted.
• When the positioning was started, the
command speed was set to 0.
3651H Axis 1 error stop • When pulses were being output or
(deceleration positioning was starting, the PLC
stop) decelerated and stopped the pulse
output due to the limit of the moving
direction or writing during RUN. (The
PLSY/DPLSY instruction stops pulse
output immediately at both limits.)
• When pulses were being output or
positioning was starting, the PLC
decelerated and stopped the pulse
output by the pulse decelerate and stop
command.
• When pulses were being output, the
command speed was changed to 0.
• When pulses were being output,
RUNPAUSE/RUNSTOP operation
was executed.
Action
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Eliminate the error that has caused the stop
and restart the positioning.
Detailed Diagnostic
information timing
Error location At instruction
information
execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At instruction
information execution
and system
configuration
information
Error location At END
information instruction
and system execution, at
configuration instruction
information execution
APPENDIX
337
Appendix 3 Error Code
A