Mitsubishi Electric MELSEC iQ-F FX5 User Manual page 337

Error Error name Error details and cause
code
3635H Axis 5 positioning • The 32-bit range was exceeded when
address error the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
3636H Axis 6 positioning • The 32-bit range was exceeded when
address error the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
3637H Axis7 positioning • The 32-bit range was exceeded when
address error the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
3638H Axis 8 positioning • The 32-bit range was exceeded when
address error the unit of the positioning address was
converted.
• The 32-bit range was exceeded when
the unit of the zero-point address was
converted.
• The total transfer distance before and
after the interrupt of the DVIT/DDVIT
instruction or 1-speed positioning with
interruption exceeded 7FFFFFFFH. Or,
when the operation was started, the
positioning address was set to 0.
• Pulses of 7FFFFFFFH or greater are
needed to specify an absolute address.
Action
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
• Start the positioning within specifications.
Detailed Diagnostic
information timing
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
Error location At END
information instruction
and system execution, at
configuration interrupt
information occurrence
APPENDIX
335
Appendix 3 Error Code
A