Threaded Hole Repair; Metric System; Conversion Formulas And Equivalent Values; Common Metric Equivalents - Chrysler 2000 LHS Owner's Manual

8 INTRODUCTION
DESCRIPTION AND OPERATION (Continued)

THREADED HOLE REPAIR

DESCRIPTION
Most stripped threaded holes can be repaired using
a Helicoil . Follow the manufacture recommendation
for application and repair procedures.

METRIC SYSTEM

DESCRIPTION
The metric system is based on quantities of one,
ten, one hundred, one thousand and one million.
MULTIPLY BY
in-lbs x 0.11298
ft-lbs x 1.3558
Inches Hg x 3.377
(60° F)
psi x 6.895
Inches x 25.4
Feet x 0.3048
Yards x 0.9144
mph x 1.6093
Feet/Sec x 0.3048
mph x 0.4470
Kilometers/ x 0.27778
Hr. (Km/h)
1 inch = 25 Millimeters
1 Foot = 0.3 Meter
1 Yard = 0.9 Meter
1 Mile = 1.6 Kilometers
Refer to the Metric Conversion Chart to convert
torque values listed in metric Newton- meters (N·m).
Also, use the chart to convert between millimeters
(mm) and inches (in.)

CONVERSION FORMULAS AND EQUIVALENT VALUES

TO GET
= Newton Meters (N·m)
= Newton Meters (N·m)
= Kilopascals (kPa)
= Kilopascals (kPa)
= Millimeters (mm)
= Meters (M)
= Meters
= Kilometers/Hr. (Km/h)
= Meters/Sec (M/S)
= Meters/Sec (M/S)
= Meters/Sec (M/S)

COMMON METRIC EQUIVALENTS

The following chart will assist in converting metric
units to equivalent English and SAE units, or vise
versa.
MULTIPLY
N·m x 8.851
N·m x 0.7376
kPa x 0.2961
kPa x 0.145
mm x 0.03937
M x 3.281
M x 1.0936
Km/h x 0.6214
M/S x 3.281
M/S x 2.237
M/S x 3.600
1 Cubic Inch = 16 Cubic Centimeters
1 Cubic Foot = 0.03 Cubic Meter
1 Cubic Yard = 0.8 Cubic Meter
TORQUE REFERENCES
DESCRIPTION
Individual Torque Charts appear at the end of
many Groups. Refer to the Standard Torque Specifi-
cations Chart for torque references not listed in the
individual torque charts.
BY TO GET
= in-lbs
= ft-lbs
= Inches Hg
= psi
= Inches
= Feet
= Yards
= mph
= Feet/Sec
= mph
Kilometers/Hr.
(Km/h)
LH