Table of Contents
Advertisement
FIGURE 6
Installing a POE Daughter Card in the FGS624P-POE or FGS624P-POE-STK device
Figure 7
shows the location of the POE daughter cards on the main board of the FGS648P-POE and FGS648P-POE-STK
devices.
FIGURE 7
Installing a POE Daughter Card in the FGS648P-POE and FGS648P-POE-STK devices.
4.
Re-assemble the device as instructed in the section
5.
Power ON the device and observe the console. The following message will appear:
Info:
PoE module detected in slot 1.
6.
Enable POE and configure POE parameters. Refer to the <Italic>FastIron Configuration Guide for information.
Reassembling the device
Reassemble the device using the following steps:
1.
Replace the cover.
2.
Re-fasten the screws on each side of the cover.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
1
"Reassembling the
device".
Initializing....
Maintaining the FGS and FGS-STK Hardware
Installing or replacing a POE daughter card
99
Advertisement
Table of Contents
