Brocade Communications Systems FastIron FGS624P Hardware Installation Manual page 42

Installing FastIron GS and FastIron GS-STK Devices
Installing the device
FIGURE 12 Attaching the long mounting brackets
3. Mount the device in the rack as illustrated in
NOTE
Although Figure 13
brackets is the same.
FIGURE 13 Installing the device in a rack
NOTE
If you are installing a device with two power supplies into a Telco rack, you must remove one of the power supplies in order to
slide the device into the rack. The back panels of the power supplies overhang the device by approximately .25 inches, making it
impossible to insert into a standard Telco rack with both power supplies installed.
4. Proceed to "Powering on the system"
42
Figure
shows a device with short mounting brackets, the procedure for securing a device with long mounting
on page 45.
13.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03