Brocade Communications Systems FastIron FGS624P Hardware Installation Manual page 35

FIGURE 2 Power supply locking screw, latches, and cover plate
1 Cover plate
2 Cover plate latches
3 Power supply locking screw
3. Remove the new power supply from the packaging.
4. With one hand, hold the bar on the front panel of the power supply. Use your other hand to support the underside of the power
supply while you insert it into the empty slot. Press gently until the connectors on the back of the supply fully engage with the
pins on the power backplane.
FIGURE 3 Inserting the power supply
Make sure you insert the power supply right-side up. It is possible to insert the supply upside down,
although the supply will not engage with the power backplane. The power supply is right-side up when the
power connector is on the left and the fan vent is on the right.
5. Press the two latches near the edges of the supply outward to lock the supply in place.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
Installing FastIron GS and FastIron GS-STK Devices
3
2
1
Installing a redundant power supply
35