Brocade Communications Systems FastIron FGS624P Hardware Installation Manual page 37

1. If necessary, before installing a power supply, remove the power supply locking screw located in the center rear of the device,
and remove the cover plate (illustrated in
power supply gently out of the device, using the handle.
FIGURE 6 Power supply locking screw and cover plate latches
1 Cover plate
2 Cover plate latches
3 Power supply locking screw
2. If the empty power supply bay has a cover plate, unlock it by pressing inward on the two latches at the edges of the cover plate
(refer to Figure 6), then remove the plate.
3. Remove the new power supply from the packaging.
4. Prepare the positive, negative, and ground wires by stripping about 1/4 in. of insulation off the end of each one. (Use 10 AWG
wire.)
5. Loosen the three screws used to hold the wires in the connectors, as shown in
NOTE
The handle on the front panel of the power supply may block access to the negative and positive terminal screws. You may
need to temporarily remove the receptacle for the positive and negative terminals if you can not access the screws used to
hold the wires in the connectors.
6. With one hand, grasp the handle on the front panel of the power supply. Use your other hand to support the underside of the
power supply while you insert it in the empty slot. Press gently so that the connectors on the back of the supply are fully engaged
with the pins on the power backplane. Refer to
Make sure you insert the power supply right-side up. It is possible to insert the supply upside down,
although the supply will not engage with the power backplane. The power supply is right-side up when the
power connector is on the left and the fan vent is on the right.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
Figure 6 on an AC device). If you are replacing an existing power supply, pull the old
Power Supply locking screw
2
1
Figure 7.
Installing FastIron GS and FastIron GS-STK Devices
Installing a redundant power supply
3
Figure 9.
37