Table of Contents
Advertisement
Maintaining the FGS and FGS-STK Hardware
Installing or replacing a POE daughter card
Installing a 2-port 10 Gbps module
Follow these procedures and refer to
1.
Remove power to the FGS or FGS-STK device. For AC power supplies, turn the switch to the OFF position. For DC power
supplies, turn off the DC power source or disconnect it from the power supply.
2.
If necessary, remove the faceplate for the 2-port 10 Gbps module located in the lower left-hand corner of the front panel. Use a
#2 Phillips-head screwdriver or flathead screwdriver to loosen the two captive screws that secure it in place. Place the blank
faceplate in a safe place for future use.
3.
Remove the new 10-Gigabit Ethernet module and faceplate from its protective packaging.
4.
Install the 10-Gigabit module in the device as shown in
•
Properly place and align the 10-Gigabit Ethernet module inside the device.
•
Push the module firmly toward the back of the device until the front panel is flush with the rest of the device. This action
causes the module connector to lock into the backplane connector.
•
Use a #2 Phillips-head screwdriver or flathead screwdriver to fasten the two captive screws on the 10-Gigabit module.
Affix the screws loosely at first, then tighten them once you are sure the module is properly positioned.
FIGURE 2
Installing a 2-Port 10 Gbps Module
5.
After installing the module, power on the system and verify that the module is working properly. Refer to the section
LEDs"
on page 70.
Installing or replacing a POE daughter card
This section provides instructions for installing or replacing a Power Over Ethernet (POE) daughter card in the FGS or FGS-STK device.
•
The FGS624P, FGS624P-STK, FGS624P-POE, and FGS624P-POE-STK have one connector slot on the main board for a
single POE daughter card, which provides support for POE power-consuming devices on all 24 10/100/1000 ports.
•
The FGS648P, FGS648P-STK, FGS648P-POE, and FGS648P-POE-STK have two connector slots on the main board for
two POE daughter cards. A single POE daughter card provides support for POE power-consuming devices on 24
10/100/1000 ports. As you look at the front of the device, a POE daughter card in the left-most connector slot provides POE
for ports 1 – 24, and the right-most connector slot provides POE for ports 25 – 48.
96
Figure 2
when installing a 10-Gigabit Ethernet Module:
G
X 4- 2X
Figure
2:
Brocade FastIron GS and GS-STK Hardware Installation Guide
"Observing
Part Number: 53-1002186-03
Advertisement
Table of Contents
