Reset Button; Network Interfaces For A Icx 6450-C Device - Brocade Communications Systems Brocade ICX 6450-C Hardware Installation Manual

Reset button

The reset button allows you to restart the system without switching the power supplies off and on
or using the CLI or Web Management Interface. When reset button is pressed, the system resets
and the software is reloaded. The button is directly below the power LED on the very left of the
device's front panel.

Network interfaces for a ICX 6450-C device

An ICX 6450-C12 device contains the following interfaces:
•
•
•
•
Slot designations
Table 1
slots 1- 3 on the front panel of an ICX 6450-C device.
TABLE 1
Slot designations for a ICX 6450-C device
Device Slot 1
(10/100/1000 BASE-T RJ45 ports)
ICX 6450-C12-PD Ports 1-12
10/100/1000 BASE-T RJ45
An ICX 6450-C device provides 12 RJ45 ports that reside on Slot 1 of the device. The 12 RJ45
ports operate at 10 Mbps or 100 Mbps half or full duplex, or at 1000 Mbps full duplex. Because all
ports support automatic MDI or MDI-X operation, you can use straight-through cables for all
network connections to PCs or servers, or to other devices or hubs. In addition, it is ideal (and
preferred) to use straight-through cables for switch-to-switch connections.
Each port supports auto-negotiation, so the optimum transmission mode (half or full duplex), and
the data rate (10, 100, or 1000 Mbps) can be selected automatically. If a device connected to one
of these ports does not support auto-negotiation, the communication mode of the port can be
configured manually.
Ports 1-4 are PoE+ and MACsec capable. Ports 5-12 are non-PoE.
RJ45 uplink ports
An ICX 6450-C device provides 4 independent uplink ports that are MACsec-capable.
The 10/100/1000 BASE-T RJ45 PD1/C1 and PD2/C2 ports, residing on slot 2 of the device, can
be used as uplink ports or additional network connections. They can also be used as PD ports.
Brocade ICX 6450-C Compact Switch Hardware Installation Guide
53-1002817-02
12 10/100/1000 BASE-T RJ45 copper connectors (Slot 1, Ports 1- 12)
-
Ports 1- 4 are dedicated PoE/PoE+ ports.
4 100M/1G ports:
2 10/100/1000 BASE-T, RJ45 ports (Slot 2, ports PD1/C1-PD2/C2); can be used as uplink or
PD ports
2 1G SFP uplink ports (Slot 3, ports F1-F2)
lists the slot designations for an ICX 6450-C device. Refer to
Network and management interfaces
Slot 2
(10/100/1000 BASE-T RJ45 uplink ports)
Ports PD1/C1-PD2/ C2
Figure 3 for the location of
Slot 3
(1G SFP uplink ports)
Ports F1-F2
1
3