Table of Contents
Advertisement
Installing FastIron GS and FastIron GS-STK Devices
Installing a redundant power supply
6.
Replace the power supply locking screw.
7.
Install the power cord, and secure it wIth the retaining bail, as shown in
NOTE
The edges of the power supply panels will extend approximately .25 in.beyond the side of the device.
FIGURE 4
Installing the AC power cord
1
Cord retaining bail
2
AC power cord
Installing a DC power supply
Use the following procedures to install DC power supplies in a FastIron GS or FastIron GS-STK device.
a DC power supply.
FIGURE 5
DC power supply front panel
Before beginning the installation, refer to the precautions in
36
1
Figure
4.
2
"Power precautions"
Brocade FastIron GS and GS-STK Hardware Installation Guide
Figure 5
shows the front panel of
on page 31.
Part Number: 53-1002186-03
Advertisement
Table of Contents
