Table of Contents
Advertisement
To change the temperature at which the device sends a warning, enter a command such as the following at the Privileged EXEC level of
the CLI:
FastIron# temperature warning 47
Syntax: temperature warning <value>
The <value> can be 0 – 125.
For IronStack devices
To change the temperature warning level for an FGS-STK device in an IronStack, enter a command similar to the following:
FGS624 Switch# temperature warning 2 82
Syntax: temperature warning <unit-id> <value>
Changing the temperature shutdown level
To change the temperature at which the device sends a warning, enter a command similar to the following:
FastIron#temperature shutdown 47
Syntax: temperature shutdown <value>
The <value> can be 0 – 125.
For IronStack devices
To change the temperature shutdown level for an FGS-STK device in an IronStack, enter a command similar to the following:
FGS624 Switch#temperature shutdown 2 90
Syntax: temperature shutdown <unit-id> <value>
Changing the device temperature polling interval
The software reads the temperature sensors and polls other hardware sensors according to the value set for the device poll time, which is
60 seconds by default. You can change the device poll time using the CLI.
To change the device poll time for standalone devices or for devices in an IronStack, enter a command similar to the following at the
global CONFIG level:
FastIron(config)# chassis poll-time 200
Syntax: chassis poll-time <value>
The <value> can be 0 – 65535.
Removing MAC address entries
You can remove the following types of learned MAC address entries from the MAC address table:
•
All MAC address entries
•
All MAC address entries for a specified Ethernet port
•
All MAC address entries for a specified VLAN
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
Managing the FGS and FGS-STK Device
Removing MAC address entries
91
Advertisement
Table of Contents
