Installing Or Replacing A 2-Port 10 Gbps Module; Removing A 2-Port 10 Gbps Module - Brocade Communications Systems FastIron FGS624P Hardware Installation Manual

Installing or replacing a 2-port 10 Gbps module

The 2-port 10-Gigabit Ethernet module is optional. You can order the FGS or FGS-STK with a 2-port 10-Gigabit module installed at the
factory, or you can upgrade your device later.
NOTE
The 1-port 10-Gigabit module on FGS624XGP, FGS624XGP-STK, FGS624XGP-POE and FGS648XGP-POE-STK models
is not field replaceable or upgradeable.
This section provides the steps for installing, removing, and replacing the 2-port 10-Gigabit Ethernet module. You will need the following
tools to perform these procedures:
•
#2 Phillips-head screwdriver or flathead screwdriver for captive screws
•
Electrostatic Discharge (ESD) kit
Figure 1 shows a 2-port 10 Gbps module.
FIGURE 1 2-Port 10 Gbps Module

Removing a 2-port 10 Gbps module

1. Remove power to the FGS or FGS-STK device. For AC power supplies, turn the switch to the OFF position. For DC power
supplies, turn off the DC power source or disconnect it from the power supply.
2. Remove the 10-Gigabit module from the device:
•
Use a #2 Phillips-head screwdriver or flathead screwdriver to loosen and remove the two captive screws on the 10-Gigabit
module.
•
Gently pull on the 10 Gbps module to disconnect it from the backplane connector. Once disconnected, remove the 10
Gbps module completely from the device.
3. Place the 10-Gigabit module in an anti-static bag for storage.
4. Do one of the following:
•
Insert a new 10-Gigabit module as instructed in the section
•
If you are removing the module without replacing it, place the blank faceplate over the opening where the 10 Gbps module
was installed. Use the two captive screws to fasten the faceplate in place.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
Maintaining the FGS and FGS-STK Hardware
"Installing a 2-port 10 Gbps
Replacing a power supply
module".
95