Brocade Communications Systems FastIron FGS624P Hardware Installation Manual page 39

FIGURE 9 DC power supply connector
1 Negative terminal screw
2 Positive terminal screw
3 48 RTN lead
4 -48 VDC lead
5 10 AWG wire
9. Connect the ground, positive, and negative wires as follows:
•
Slip the 10 AWG ground wire into the opening under the negative (—) mark until the wire is fully in place, then use the
crimper to crimp the lug snugly onto the wire. Gently pull the lug away from the wire to verify that the lug is securely
fastened.
•
Connect the -48 VDC lead to the negative (—) terminal and tighten the negative terminal screw.
•
Connect the 48 RTN lead to the positive (+) terminal and tighten the positive terminal screw.
•
Figure 10 shows how to connect the wires on a DC power supply.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
1 2
3
4
5
Installing FastIron GS and FastIron GS-STK Devices
Installing a redundant power supply
39