Table of Contents
Advertisement
EPREM Upgrade for FastIron GS Devices
Upgrading software
FIGURE 3
EEPROM Socket Locations on FGS 624 and 648 Devices
1
Device front panel
2
Power supplies
3
Device rear panel
4
Pin 1 and socket hole 1
5
EEPROM socket
6
EEPROM
7
Memory DIMM
3.
Replace the cover:
•
Hold the cover on each side at the center and align the front of the cover with the end of the serial interface on the front
panel, so that the cover extends slightly past the front panel of the device.
•
Slide the cover backwards until it is fully flush with the top of the device and slides into place.
•
Re-insert the cover screws.
4.
If applicable, re-attach the rack mounting ears.
5.
Reinstall the device in the equipment rack, if applicable.
6.
Re-insert any power cables and power on the device.
Your EPREM upgrade is now complete. Refer to the <Italic>FastIron Configuration Guide for information about the Edge Layer 3 features
available with release 04.3.01.
Upgrading software
After you install your Edge Layer 3 EEPROM, you will need to upgrade your software. Refer to the release notes for more information.
52
1
2
3
4
5
2
7
Brocade FastIron GS and GS-STK Hardware Installation Guide
6
Part Number: 53-1002186-03
Advertisement
Table of Contents
