Table of Contents
Advertisement
Stacking Upgrade for the FastIron GS
Upgrading hardware
Upgrading hardware
You need a Phillips-head screwdriver and an ESD wrist strap to perform this procedure. You also need a static-free work area.
WARNING
Disconnect the power cord from all power sources to completely remove power from the
device.
ACHTUNG
Ziehen Sie das Stromkabel aus allen Stromquellen, um sicherzustellen, dass dem Gerät
kein Strom zugeführt wird.
AVERTISSEMENT
Débranchez le cordon d'alimentation de toutes les sources d'alimentation pour couper
complètement l'alimentation du dispositif.
ADVERTENCIA
Para desconectar completamente la corriente del instrumento, desconecte el cordón de
corriente de todas las fuentes de corriente.
To perform the upgrade:
1.
Remove all power cables from the device.
2.
Remove the device from the equipment rack, if necessary, and place the device in a static-free work area.
3.
Put on the supplied ESD wrist strap and attach the clip end to a metal surface (such as an equipment rack) to act as ground.
4.
Disassemble the device as follows (refer to
•
Use a Phillips-head screwdriver to remove the two screws in the bottom corners of each side. If rack mounting ears are
installed, remove the four screws that hold each ear to the device. Refer to
•
Turn the device so that the front (where the port connectors are) is facing you.
•
Slide the cover backwards to free the lip edge of the cover from the front plate. Make sure the cover is completely free of
the front panel.
FIGURE 1
Removing Cover Screws on FGS Devices.
5.
Remove the cover by sliding it back slightly and then lifting it off as shown in
54
Table 0.3:
Figure 1
on page 54):
Figure
1.
Sl ot 3
Figure
2.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
Advertisement
Table of Contents
