Power Supplies - Brocade Communications Systems FastIron FGS624P Hardware Installation Manual

TABLE 4 LEDs (Continued)
LED Position
PS1 Left-most LED
beneath the console
port
PS2 Middle LED beneath
the console port
Stacking LEDs
Fiber optic modules
Table 18 in the chapter "Hardware
FGS-STK devices.
Table 3 describes the output of the show media command for each media type.

Power supplies

Each FGS or FGS-STK device comes with one alternating-current (AC) power supply (part number RPS-FGS) or direct-current (DC)
power supply (part number RPSDC-FGS), depending on how it was ordered from the factory. All models have two power supply slots,
enabling you to install a second power supply for redundancy (if applicable) or for additional POE power. You can use any combination of
AC and DC supplies in the same device.
Figure 15 shows the front panel of the AC power supply used with FastIron GS and GS-STK devices.
FIGURE 15 RPS-FGS AC power supply front panel
Figure 16 shows the front panel of the DC power supply used with FastIron GS and GS-STK devices.
Brocade FastIron GS and GS-STK Hardware Installation Guide
Part Number: 53-1002186-03
State Meaning
On Power supply 1 is installed and is functioning
normally. Power supply 1 is located in the
right-hand bay (when you are facing the rear of the
device).
Off Power supply 1 is not installed or is not providing
power.
On Power supply 2 is installed and is functioning
normally. Power supply 2 is located in the
left-hand bay (when you are facing the rear of the
device).
Off Power supply 2 is not installed or is not providing
power.
Specifications"lists the types of fiber optic modules (SFPs and XFPs) supported on Brocade FGS and
Product Overview
Hardware features
25