Installing The 1U And 2U Non-Port Side Fixed-Mount Rack Kit (15"-20") For Four-Post Racks (Xna-000072 And Xna-100072) - Brocade Communications Systems 300 Hardware Installation Manual

1. Right rack mount bracket
2. Rack post
3. Three-hole rack nut bar, 8-32
Installing the 1U and 2U Non-Port Side Fixed-Mount
Rack Kit (15"-20") for Four-Post Racks
(XNA-000072 and XNA-100072)
Use the following instructions to install a fixed-port device in a 19-inch (48.3 cm) EIA rack using the 1U and 2U Non-port Side Fixed
Rack Mount Kit (15"-20") for Four-Post Racks.
Observe the following when mounting this device:
• Use Electronic Industries Association (EIA) standard racks. Provide space in a 19-inch (48.3 cm) EIA rack, as required for the
device type, with a minimum distance of 24 in. (60.96 cm) and a maximum distance of 32 in. (81.28 cm) between the front
and back posts.
• The rack kit is designed so that the device is installed with the non-port side flush with the front posts of the rack.
• Two people are required to install the device in a rack. One person holds the device, while the other secures the device to the
rack.
• Before mounting your device, review any specific installation and facility requirements in this Hardware Installation Guide.
Brocade 300 Hardware Installation Guide
53-1000862-12

Installing the 1U and 2U Non-Port Side Fixed-Mount Rack Kit (15"-20") for Four-Post Racks (XNA-000072 and XNA-100072)

4. Alignment washer (previously installed)
5. Phillips screw, 10-32 x 1/2 in., black
47