Sirona galileos comfort plus Operating Instructions Manual page 61

Sirona Dental Systems GmbH
Operating Instructions GALILEOS Comfort PLUS (CANADA) GALILEOS
64 91 208 D3437
D3437.201.09.07.02 12.2015
● The exposure is complete when ...
– The comment line displayed on the touchscreen switches from
"Exposure in progress" to "R button, confirm exposure data".
– The message "H 320" and the program number are alternately
displayed on the remote control.
– The actual mAs value is shown next to the program number at the
end of the exposure.
– A short, pulsed tone sequence can be heard at the end of the
exposure (this function can be deactivated by the service
engineer).
The end of the exposure cycle can also be seen on the SIDEXIS monitor
Display on the Sidexis monitor
when the progress bar indicates 100%.
Press the "R" key to confirm the exposure.
Then press the "R" key again to move the unit to the entry position.
The patient can now step out of the unit.
CAUTION
Never switch off the X-ray unit during the transmission of an image. This
process takes approx. 2.5 minutes.
After completion of the exposure
After completion of the exposure WW
On completion of the exposure, the image is reconstructed and displayed
in the reconstruction software. Depending on the program selected and
the PC system used, it may take from 2.5 to 5 minutes to display all of the
views on the screen.
IMPORTANT
The operation of the visualization software is described in the attached
GALAXIS Operator's Manual.
"Area dose product"
Display
Following the exposure, the
"Describe image"
dialog box in SIDEXIS XG.
"[A]nalysis"
Open the dialog box via
displayed at the upper edge of the window.
The displayed dialog box shows the available image information for the
currently active X-ray.
7.7 Releasing the exposure
for SIDEXIS XG
"Area dose product"
is displayed in the
"Findin[g]s"
→ or via an icon
7 Operation
61