HP A6600 Configuration Manual page 196

Configuring an uplink policy for the network-side port
The uplink policy on the network-side port modifies the CVLAN ID of incoming traffic.
To configure an uplink policy for the network-side port:
To do...
1. Enter system view
2. Create a class and enter class
view
3. Specify a foreign CVLAN as a
match criterion
4. Specify a local SVLAN as a match
criterion
5. Return to system view
Create a traffic behavior and enter
6.
traffic behavior view
7. Configure a CVLAN marking
action to replace the foreign
CVLAN ID with a local CVLAN ID
8. Return to system view
9. Create a QoS policy and enter
QoS policy view
10. Associate the class with the
behavior
Configuring a downlink policy for the customer-side port
The downlink policy on the customer-side port replaces local SVLAN and CVLAN pairs with foreign
SVLAN and CVLAN pairs.
To configure a downlink policy for the customer-side port:
To do...
1. Enter system view
2. Create a class and enter class
view
3. Specify a local CVLAN as a match
criterion
4. Specify a local SVLAN as a match
criterion
5. Return to system view
6. Create a traffic behavior and enter
traffic behavior view
7. Configure a CVLAN marking
action to replace the local CVLAN
ID with a foreign CVLAN ID
Use the command...
system-view
traffic classifier tcl-name [ operator
and ]
if-match customer-vlan-id vlan-id
if-match service-vlan-id vlan-id
quit
traffic behavior behavior-name
remark customer-vlan-id vlan-id
quit
qos policy policy-name
classifier tcl-name behavior
behavior-name
Use the command...
system-view
traffic classifier tcl-name [ operator
and ]
if-match customer-vlan-id vlan-id
if-match service-vlan-id vlan-id
quit
traffic behavior behavior-name
remark customer-vlan-id vlan-id
189
Remarks
—
Required.
Repeat these steps to
create one class for each
local SVLAN and foreign
CVLAN pair.
Required.
Repeat these steps to
configure one CVLAN
marking action for each
local SVLAN and foreign
CVLAN pair.
Required.
Required.
Repeat this step to create
other class-behavior
associations.
Remarks
—
Required.
Repeat these steps to
create one class for each
local CVLAN and SVLAN
pair.
Required.
Repeat these steps to
create one VLAN marking
behavior for each local