Gvrp Configuration Task List; Configuring Gvrp Functions - HP A6600 Configuration Manual

GVRP configuration task list

Complete these tasks to configure GVRP:
Task

Configuring GVRP functions

Configuring the garp timers
GVRP configuration made in Ethernet interface view or Layer 2 aggregate interface view takes effect on
the current interface only. GVRP configuration made in port group view takes effect on all member ports
in the group.
GVRP configuration made on a member port in an aggregation group takes effect only after the port is
removed from the aggregation group.
Configuring GVRP functions
Before enabling GVRP on a port, you must enable GVRP globally. In addition, GVRP can be configured
only on trunk ports, and you must assign the involved trunk ports to all dynamic VLANs.
To configure GVRP functions on a trunk port:
To do...
1. Enter system view
2. Enable GVRP globally
3. Enter Ethernet
interface view,
Layer 2 aggregate
interface view, or
port-group view
4. Configure the link type of the ports as trunk
5. Assign the trunk ports to all VLANs
6. Enable GVRP on the ports
7. Configure the GVRP registration mode on
the port
For more information about the port link-type trunk and port trunk permit vlan all commands, see Layer
2—LAN Switching Command Reference.
GVRP is mutually exclusive with service loopback.
Use the command...
system-view
gvrp
Enter Ethernet
interface view or Layer interface interface-type
2 aggregate interface interface-number
view
port-group manual
Enter port-group view
port-group-name
port link-type trunk
port trunk permit vlan all
gvrp
gvrp registration { fixed |
forbidden | normal }
135
Remarks
Required
Optional
Remarks
––
Required.
Globally disabled by
default.
Required.
Perform either of the
commands.
Required.
Access by default.
Required.
By default, a trunk port is
assigned to VLAN 1 only.
Required.
Disabled by default.
Optional.
normal by default.