Configuring The Garp Timers - HP A6600 Configuration Manual

GVRP can run on only the MSTP CIST, and the blocked ports on the CIST cannot receive/send GVRP
packets.
Do not enable both GVRP and remote port mirroring. Otherwise, GVRP may register the remote probe
VLAN to unexpected ports, resulting in undesired duplicates to be received by the monitor port. For more
information about port mirroring, see Network Management and Monitoring Configuration Guide.
Enabling GVRP on a Layer 2 aggregate interface enables both the aggregate interface and all selected
member ports in the corresponding link aggregation group to participate in dynamic VLAN registration
and deregistration.

Configuring the garp timers

To configure the GARP timers:
To do...
1. Enter system view
2. Configure the GARP LeaveAll timer
3. Enter Ethernet
interface view,
Layer 2
aggregate
interface view, or
port-group view
4. Configure the Hold timer
5. Configure the Join timer
6. Configure the Leave timer
As shown in 0, the value ranges for GARP timers are dependent on one another:
• If you want to set a value beyond the value range for a timer, you may change the value range by
tuning the value of another related timer.
If you want to restore the default settings of the timers, restore the Hold timer first, and then the Join,
•
Leave, and LeaveAll timers.
Use the command...
system-view
garp timer leaveall
timer-value
Enter Ethernet or Layer
interface interface-type
2 aggregate interface
interface-number
view
port-group manual
Enter port-group view
port-group-name
garp timer hold timer-value
garp timer join timer-value
garp timer leave timer-value
136
Remarks
––
Optional.
The default is 1000
centiseconds.
The LeaveAll timer applies
to all ports.
Required.
Perform either of the
commands.
Optional.
10 centiseconds by
default
Optional.
20 centiseconds by
default
Optional.
60 centiseconds by
default