Protocols And Standards; Lldp Configuration Task List; Performing Basic Lldp Configuration; Enabling Lldp - HP A6600 Configuration Manual

Protocols and standards

IEEE 802.1AB-2005, Station and Media Access Control Connectivity Discovery
•
ANSI/TIA-1057, Link Layer Discovery Protocol for Media Endpoint Devices
•
DCB Capability Exchange Protocol Specification Rev 1.0
•
DCB Capability Exchange Protocol Base Specification Rev 1.01
•

LLDP configuration task list

Complete these tasks to configure LLDP:
Task
Performing basic LLDP
configuration
Configuring CDP compatibility
Configuring LLDP trapping
LLDP-related configurations made in Ethernet interface view take effect only on the current port, and those
made in port group view take effect on all ports in the current port group.

Performing basic LLDP configuration

Enabling LLDP

To make LLDP take effect on certain ports, you must enable LLDP both globally and on these ports.
To enable LLDP:
To do...
1. Enter system view
2. Enable LLDP globally
3. Enter
Ethernet
interface
Enabling LLDP
Setting the LLDP operating mode
Setting the LLDP re-initialization delay
Enabling LLDP polling
Configuring the advertisable TLVs
Configuring the management address and its
encoding format
Setting other LLDP parameters
Setting an encapsulation format for LLDPDUs
Use the command...
system-view
lldp enable
Enter Layer 2/Layer 3
interface interface-type
Ethernet interface
interface-number
view
204
Remarks
Required
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
—
Required.
By default, LLDP is globally
disabled.
Required.
Use either command.